Before and after using of paper cone machine
When used in paper cone machine:
1. cut low, such as using the ventilation machine, paper cutting, paper cutting height can't exceed 125mm, and according to the size requirement, with mei pressure iron binding. Only paper cutting machine tool, can't cut the other plate, two or more persons, should cooperate with each other, work, not reached into weight and blades, to prevent a cut. Such as using a special cutter, not reached into the spindle rotation, to prevent injury.
2. edge grinding, prevent leg into paper axis; adjust machine, pay attention to the emery cloth wheel grinding.
After the paper cone machine used:
The equipment must be someone who's in charge of, it is forbidden to others casually misuse. Each part of the machine it is strictly prohibited to put in work, card, measuring tool and other sundry, operation staff shall not leave work without authorization. Maintenance process should pay attention to not let the motor burn out, so the voltage must be stable, check all the internal parts to observe it's specific consumption level, the wear to a certain extent to replace parts. Reassemble level was used to measure and adjust the roughness of the pump, check and adjust the alignment of coupling. Little maintenance to keep a short time, take long time to maintain, use paper cone machine keep in a good working condition.
- Pre：New technology in paper cone m 2022/8/15
- Next：Introduction to a few big char 2019/12/2
